![]() This will mean the wires are completely hidden when we finish off the clock by adding the 3D printed sleaves to the shelves (which we have not yet printed yet so don't panic!).įor the next strip, take another set of 23cm long wires and solder these to the outgoing side (the end the data flow arrows are pointing towards) of a fresh strip of nine LEDs. Whenever you are routing wires along the outside perimeter of the clock ensure you use the inside holes on the wire guides. Now route the wires at the corner of the clock face down through the wire guide on the support they are on, through and into the adjacent support and up. Remove the self-adhesive backing from the rear of the LEDs and also apply some glue to the top of the LED mount (for extra grip as I found sometime mine would come unstuck without the additional glue) you can then position the strip in place ensuring that the data directional arrows are pointing towards the top of the clock. Attach two separate sets of 23cm long wires to both ends of one of the 9 long LED strips from earlier. Our first LED strip will sit on the white LED mount above the unique support we printed to house the electronics in the top right corner. Pay good attention to these as you assemble your clock. There are little arrows going along the length of the LED strips which represent the direction of data flow. The order in which the strips are connected, and their orientation, is very important. Now that the LEDs and their wires are prepared we can start to assemble them onto the front of our clock face.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |